Service Manual

7.Install bearing(57), three A-plates(95), three friction plates
(98), C-plate(97), B-plate(96), two seal rings(56) onto
PTO shaft(75). [Fig.9]
8.Install two bearings(93) and ring(87) into gear(77).
[Fig.9] (PTO gear cmp)
9.Install key(92) onto PTO shaft(75). And install three rods
(90), PTO gear cmp into clutch cylinder cmp(78). And
install this assembly onto B-plate(96). And install spacer
(89) and bearing(93) onto PTO shaft(75). [Fig.10]
(PTO cmp)
*Avoid damage of machined surfaces(gear(77), shaft(74)).
*If damage is detected, seal ring(56) must be replaced.
*When installing, take care of the direction of key(92).
Fig.10
Fig.8
X3
Fig.9
PTO cmp
92
X3
90
78
89
93
93
87
77
X2
PTO gear cmp
96
97
98
95
X3
56
X2
75
57
PTO gear cmp
PTO cmp
96
4
take care of
the direction.