Service Manual

14.Install shaft(input cmp, shaft(pump R cmp,
shaft(pump L cmp and pipe(A cmp(32) into housing
(27). [Fig.15]
15.Install two pins(40) into housing(27). And install
packing(44) and housing(43) onto housing(27).
And install fifteen bolts(45) into housing(43). Tighten
screws evenly in a crossing pattern until they are snug.
And install oil seal(42) and spacer(37) and ring(41)
into housing(43). [Fig.16]
16.Install plug(38), O-ring(39), two plugs(23) and
O-rings(24). [Fig.17]
*Avoid damage of machined surfaces(housings, gears,
shafts).
*When installing, take care not to damage lip of
oil seal(42).
Fig.16
41
X2
37
42
40
44
Fig.17
45
X15
24
23
23
24
39
38
43
27
Fig.15
33
34
X2
Shaft(pump L cmp
Shaft(pump R cmp
Shaft(input cmp
33
34
X2
Housing(gear , Shaft , Gear
32
Tightening torque
19.6±1.9Nm
Tightening torque
19.6±1.9Nm
Tightening torque
24.5±2.5Nm
Tightening torque
24.5±2.5Nm
6