Service Manual

Fig.28
25
127
X8
Fig.27
31
40
X2
51
X2
Fig.26
23.Install two valve plates(9) onto
center case(3). And install two
bypass valve cmp(31),
two CR-valve F cmp(7),
two CR-valve R cmp(8) into
center case(3). [Fig.25]
24.Center case assembly [Fig.26]
25.Install two pins(40) into housing
(27). And install packing(31) and
center case assembly onto housing
(27). [Fig.27]
Fig.25
X2
X2
9
18
7
8
7
8
3
Center case
26.Install key(127) onto shaft(58). And install eight
bolts(25) into center case(3). [Fig.28]
*Put clean grease on mating surface between
center case(3) and valve plates(9) to prevent parts
come off.
*Coat oil onto surface of valve plates(9) to prevent
initial wear.
*Do not drop valve plates(9) when installing
center case assembly.
*Avoid damage of machined surfaces(center case(3)
and housing(27)).
Tightening torque
24.5±2.5Nm
Tightening torque
8±1Nm
Tightening torque
34.3±3Nm
Tightening torque
34.3±3Nm
Tightening torque
34.3±3Nm
Tightening torque
34.3±3Nm
Center case assembly
58
Center case
assembly
9