Operator's Manual

6.Cleantheareaaroundthehydraulic-uidlter
andremovethelter(Figure72).
7.Installanewhydraulic-uidlterandturnthe
lterclockwiseuntiltherubbersealcontactsthe
lteradapter,thentightenthelteranadditional
2/3to3/4turn.
8.Installthe4drainplugs.
Note:Thewheelmotordrainplugsare
magnetic;wipethemcleanbeforeinstalling.
9.Removethell-portplugonthetopofeach
wheelmotor(Figure73).
A.Filleachwheelmotorwithapproximately
1.4L(1.5USqt)ofT oroRubyTransmission
Fluid.
B.Installthell-portplugs.
g235097
Figure73
1.Fillport
10.Removethereservoircapanddipstickfromthe
hydraulic-uidtank.
11.Add7.6L(8USqt)ofuidtothereservoir.
12.Raisetherearofmachineupandsupportitwith
jackstands(orequivalentsupport)justhigh
enoughtoallowthedrivewheelstoturnfreely.
13.Starttheengineandcheckforuidleaks.
Allowtheenginetorunforabout5minutes,then
shutitoff.
14.After2minutes,checkthelevelofthehydraulic
uid;refertoCheckingtheHydraulic-FluidLevel
(page54).
MowerDeck
Maintenance
LevelingtheMowerDeck
SettinguptheMachine
Note:Ensurethatthemowerdeckislevelbefore
matchingtheheightofcut(HOC).
1.Parkthemachineonalevelsurface,disengage
theblade-controlswitch,andengagetheparking
brake.
2.Shutofftheengine,removethekey,andwait
forallmovingpartstostopbeforeleavingthe
operatingposition.
3.Checktirepressureofthedrivetires.
Ifneeded,adjustto124kPa(18psi).
4.Positionthemowertothe76mm(3inches)
height-of-cutposition.
LevelingtheDeck
1.Positionthemachineonaatsurface.
2.Shutofftheengine,waitforallmovingpartsto
stop,removethekey,andengagetheparking
brake.
3.Checkthetirepressureinthedrivetires.
4.Usingthedeck-liftswitch,movethedeckheight
outofthetransportposition(or5-1/2inches
(140mm)cuttingheight).
g227689
Figure74
1.Height-of-cutbracket2.Height-of-cutpin
5.Inserttheheight-adjustmentpinintothe76mm
(3inches)height-of-cutlocation.
6.Releasethetransportlockandallowthedeckto
lowertothecuttingheight.
56