Operator's Manual

Assembly
9
DESCRIPTION USEQTY.
Pivot pin assembly
Hairpin cotter
2
2
Install mower attachment
Key
Safety Booklet
Operator’s Manual
Engine Operator’s Manual
Parts Catalog
Registration card
2
1
1
1
1
1
Read before operating machine
For ordering parts
Fill out and return to Toro
Install Drive Wheels
1. Jack up front of unit and remove lug nuts from
studs (Fig. 1).
2. Install drive wheels onto studs and secure with
previously removed 1/2–13 lug nuts (Fig. 1).
3. Torque lug nuts to 75 ft–lb (101 N
m).



m–3226
Figure 1
1. Stud
2. Wheel
3. Lug nut 1/2–13
Install Castor Wheel
1. Remove nuts, washers, spacer and axle shaft
from fork (Fig. 2).
2. Jack up rear of unit and install rear wheel into
castor fork (Fig. 2).
3. Place wheel between fork and slide axle through
bearings (Fig. 2).
4. Secure axle with
5. Torque nuts to 75 ft–lb (55 N⋅m).
6. Grease castor wheel bearings (Fig. 2).




m–3227




Figure 2
1. Wheel assembly
2. Axle
3. Washer 1/2” (13 mm)
4. Spacer
5. Nut 1/2–13
6. Jam nut 1/2–13
Check the air pressure in the front and rear tires: refer
to Tire Pressure in Maintenance section.