Operator's Manual

Operation
15
Stopping
1. Move the throttle lever to “SLOW” (Fig. 5).
2. Set the parking brake.
3. Turn the ignition key to “OFF” (Fig. 6).
Note: If the engine has been working hard or
is hot, let it idle for a minute before
turning the ignition key “OFF.” This
helps cool the engine before it is
stopped. In an emergency, the engine
may be stopped by turning the ignition
key to “OFF.”
4. Pull wire off spark plug(s) to prevent possibility
of accidental starting before transporting or
storing machine.
5. Close fuel shut off valve, under fuel tank before
transporting or storing machine.
IMPORTANT: Make sure fuel shut off valve
is closed before transporting or storing
machine, as fuel leakage may occur.
Operating Power Take Off
(PTO)
The power take off (PTO) switch engages and
disengages power to the attachment clutch.
Engaging the Power Take Off (PTO)
1. Move motion control levers to neutral to stop the
machine.
2. Raise the cover and move the power take off
(PTO) switch to the “ON” position to engage
(Fig. 7).
m–2721
3
2
1
Figure 7
1. Cover
2. ON-Engaged
3. OFF-Disengaged
Disengaging the Power Take Off (PTO)
1. Move motion control levers to neutral to stop the
machine.
2. Lower the cover of the power take off (PTO)
switch. This moves the switch to the “OFF”
position to disengage (Fig. 7).