Operator's Manual

Operation

Positioning the Seat

The seat can move forward and backward. Position

the seat where you have the best control of the

machine and are most comfortable.

1. To adjust, tip seat forward and loosen the seat

mounting bolts (Fig. 10).

2. Slide the seat to the desired position in the

adjusting slots and tighten the mounting bolts.

1200

m–3280

Figure 10

1. Adjustment slot

2. Mounting bolt

Pushing the Machine by Hand

IMPORTANT: Always push the machine by

hand. Never tow the machine because

hydraulic damage may occur.

To Push the Machine

1. Disengage the power take off (PTO) and turn the

ignition key to “OFF” to stop the engine.

2. Rotate pump by-pass valves counterclockwise 2

turns to push. This allows hydraulic fluid to

by-pass the pump enabling the wheels to turn

(Fig. 11).

IMPORTANT: Rotate by-pass valve a

maximum of 2 turns so the valve does not

come out of the body causing fluid to run out.

3. Release the parking brake.

To Operate the Machine

1. Turn the by-pass valves in to operate (Fig. 11).

Note: The machine will not drive unless

by-pass valves are turned in.

m–3305

Figure 11

1. By-pass valve