Operator's Manual

CAUTION
Childrenorbystandersmaybeinjuredifthey
moveorattempttooperatethetractorwhileitis
unattended.
Alwaysremovetheignitionkeyandsettheparking
brakewhenleavingthemachineunattended,even
ifjustforafewminutes.
AdjustingtheControlLever
Resistance
Thetopdampermountingboltcanbeadjustedto
obtainadesiredmotioncontrolleverresistance.Refer
toFigure19forthemountingoptions.
Torquetheboltto200in-lb(22.6N⋅m).
Figure19
1.Damper4.Mediumresistanceor
mediumfeel
2.Motioncontrolbracket
5.Leastresistanceorsoftest
feel
3.Mostresistanceorrmest
feel
AdjustingtheHeight-of-Cut
Theheight-of-cutisadjustedfrom1-1/2to5inch
(38to127mm)in1/4inch(6mm)incrementsby
relocatingthepinintodifferentholelocations.
1.Raisetheheight-of-cutlevertothetransport
position(alsothe5inch(127mm)cuttingheight
position)(
Figure20).
Figure20
1.Heightofcutlever
2.Pin
2.Toadjust,removethepinfromtheheight-of-cut
bracket(Figure20).
3.Selectaholeintheheight-of-cutbracket
correspondingtotheheight-of-cutdesiredand,
insertthepin(
Figure20).
4.Movethelevertotheselectedheight.
AdjustingtheAnti-Scalp
Rollers
Wheneveryouchangetheheight-of-cut,itis
recommendedtoadjusttheheightoftheanti-scalp
rollers.
AdjustingtheOuterRoller
1.DisengagethePTO,movethemotioncontrol
leverstotheneutrallockedposition,andsetthe
parkingbrake.
2.Stoptheengine,removethekey,andwaitforall
movingpartstostopbeforeleavingtheoperating
position.
3.Afteradjustingtheheight-of-cut,removetheange
nut,bushing,spacer,andbolt(
Figure21).
21