Setup Instructions

FormNo.3358-423RevB

ZeroTurnRadiusMowers

Allmodels

SetupInstructions

LooseParts

Usethechartbelowtoverifythatallpartshavebeenshipped.

ProcedureDescription

Qty.

Use

Nopartsrequired

–

Setupthemotioncontrollevers.

Nopartsrequired

–

Connectthebattery.

IgnitionKey1

Hosecoupling1

Operator’sManual

EngineOperator’sManual

OperatorTrainingMaterial

CompletetheSetup.

Note:Determinetheleftandrightsidesofthemachinefromthenormaloperatingposition.

SettingUptheMotionControlLevers

NoPartsRequired

Procedure

1.Removetheupperbolt(3/8x1inch)andwasher;loosenthelowerbolt(3/8x1inch)asshowninFigure1.

Raisethemotioncontrollevers.

2.Aligntheholesinthemotioncontrolleverwiththeholesinthecontrolarmshaftandinstalltheboltandwasher

removedpreviously(

Figure1).Handtightenallfasteners.Repeatthisforbothcontrolslevers.

Figure1

PrintedintheUSA.OriginalInstructions(EN)

AllRightsReserved

PAGE 1
Form No. 3358-423 Rev B Zero Turn Radius Mowers All models Setup Instructions Loose Parts Use the chart below to verify that all parts have been shipped. Procedure 1 2 3 Description Use Qty. No parts required – Set up the motion control levers. No parts required – Connect the battery. Ignition Key Hose coupling Operator’s Manual Engine Operator’s Manual Operator Training Material 1 1 1 1 1 Complete the Setup.
PAGE 2
3. Open the motion control lever and raise the seat (Figure 2). Move the control levers back to the center position (neutral). G006481 Figure 2 4. Verify the motion control levers are properly aligned (Figure 3). Adjust as necessary. Tighten all fasteners. G006482 Figure 3 1 2 2 3 4 5 Connecting the Battery No Parts Required Procedure 1. Locate the battery and negative battery cable in the left hand console of the machine. 2.
PAGE 3
Completing the Setup Parts needed for this procedure: 1 Ignition Key 1 Hose coupling 1 Operator’s Manual 1 Engine Operator’s Manual 1 Operator Training Material Procedure Checking the Tire Pressure Check the front and rear tires for proper inflation. Refer to Checking the Tire Pressure in the Operator’s Manual for the recommended inflation pressure. Checking the Side Discharge Chute Remove the packing restraint holding the side discharge chute up and lower the chute into place.
PAGE 4
Notes: 4