Setup Instructions

Printed in the USA

 2001 by The Toro Company

8111 Lyndale Avenue South

Bloomington, MN 55420-1196

Z17-44

TimeCutter Z Riding Mower

Model No. 74401—Serial No. 220000001 and Up

Form No. 3327-130

Setup Instructions

Loose Parts

Note: Use the chart below to verify that all parts have been shipped.

Description Qty. Use

Bolt, 1/4 x 3/4 in.

Washer, 1/4 in.

Nut, 1/4 in.

Installing the battery

Seat

Knob

Flat washer, 5/16 in.

Installing the seat

Left-hand control lever

Right-hand control lever

Bolt, 3/8 x 1 in.

Curved washer, 3/8 in.

Installing the motion control levers

Key

CE certificate

Operator’s Manual

Engine Operator’s Manual

Read before operating the machine.

Registration card 1 Fill out and return to Toro.

PAGE 1
Form No. 3327-130 Z17-44 TimeCutter Z Riding Mower Model No. 74401—Serial No. 220000001 and Up Setup Instructions Loose Parts Note: Use the chart below to verify that all parts have been shipped. Description Qty. Bolt, 1/4 x 3/4 in. 2 Washer, 1/4 in. 2 Nut, 1/4 in. 2 Seat 1 Knob 2 Flat washer, 5/16 in. 2 Left-hand control lever 1 Right-hand control lever 1 Bolt, 3/8 x 1 in. 4 Curved washer, 3/8 in.
PAGE 2
Activating the Battery Warning Bulk electrolyte with 1.260 specific gravity must be purchased from a local battery supply outlet. Charging the battery produces gasses that can explode. Danger Never smoke near the battery and keep sparks and flames away from battery. Battery electrolyte contains sulfuric acid which is a deadly poison and causes severe burns. 7.
PAGE 3
4. Slide the shoulder bolts on the bottom of the seat into the slots on the seat support (Fig. 5). Secure the seat to the seat support with the flat washers and knobs removed in step 2 (Fig. 5). 1 4 2 3 m–5215 2 Figure 3 1. Control arm 2. Bolt, 3/8 x 1 in. 3. Curved washer, 3/8 in. 4. Control arm shaft 3 3. Position the levers so that the bolts are in the center of the slots on the lever mounting plate and tighten the bolts until they are snug. 1 m–5579 Figure 5 4.
PAGE 4