Setup Instructions

ManualsBrandsToro ManualsRiding EquipmentToro 74527

FormNo.3408-597RevA

GrandStand

MultiForceSnowMachine

ModelNo.74527—SerialNo.4000000000andUp

SetupInstructions

WARNING

CALIFORNIA

Proposition65Warning

ThisproductcontainsachemicalorchemicalsknowntotheStateofCaliforniato

causecancer,birthdefects,orreproductiveharm.

Setup

LooseParts

Usethechartbelowtoverifythatallpartshavebeenshipped.

ProcedureDescription

Qty.

Use

Nopartsrequired

–

Checkthetirepressure.

Nopartsrequired

–

Checktheengine-oillevel.

Nopartsrequired

–

Addfueltothemachine.

Nopartsrequired

–

Checkthehydraulic-uidlevel.

Nopartsrequired

–

Chargethebattery.

Nopartsrequired

–

Installthebatterycables.

Nopartsrequired

–

Checkthemachinebeforedeliveryto

thecustomer.

Operator'sManual

Engineowner'smanual1

Registrationcard1

Key2

Deliverthemachinetothecustomer.

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.T oro.com.

OriginalInstructions(EN)

PrintedintheUSA

AllRightsReserved

*3408-597*A

Summary of content (8 pages)

PAGE 1
Form No. 3408-597 Rev A GrandStand® Multi Force Snow Machine Model No. 74527—Serial No. 4000000000 and Up Setup Instructions WARNING CALIFORNIA Proposition 65 Warning This product contains a chemical or chemicals known to the State of California to cause cancer, birth defects, or reproductive harm. Setup Loose Parts Use the chart below to verify that all parts have been shipped. Procedure 1 2 3 4 5 6 7 8 © 2016—The Toro® Company 8111 Lyndale Avenue South Bloomington, MN 55420 Description Qty.
PAGE 2
1 3 Checking the Tire Pressure Adding Fuel to the Machine No Parts Required No Parts Required Procedure Procedure Pressure: 83 to 97 kPa (12 to 14 psi) Add fuel to the machine before starting it. Refer to your Operator’s Manual for the correct fuel and procedure. Note: The front caster wheel is a semi-pneumatic tire and does not need to be checked. Note: Ensure that the fuel-shutoff valve is open before attempting to start the engine. Check the air pressure in the drive tires.
PAGE 3
5 6 Charging the Battery Installing the Battery Cables No Parts Required No Parts Required Procedure Procedure Install the positive battery cable, then install the negative battery cable (Figure 3). WARNING CALIFORNIA Proposition 65 Warning Battery posts, terminals, and related accessories contain lead and lead compounds, chemicals known to the State of California to cause cancer and reproductive harm. Wash hands after handling.
PAGE 4
7 Checking the Machine Before Delivery to the Customer No Parts Required Procedure Before delivering the machine to the customer, ensure that you perform or have performed the procedures listed in the following table and initial each when finished. Refer to the Operator's Manual for instructions on performing these procedures. Initial Check Procedure Check the tire pressure. Check the level of the machine. Check the engine-oil level. Check the hydraulic-fluid level.
PAGE 5
Dealer Initial Customer Initial Check Procedure Show the customer where the following features are located and how they function: • Fuel-tank cap • Oil-fill cap/Oil dipstick • Spark plug(s) • Engine-oil filter • Engine-oil drain • Fuel gauge, valve, filter, and hose • Air filter • Hydraulic-bypass valves(if applicable) • Hydraulic-fluid reservoir (if applicable) • Hydraulic filter (if applicable) • Battery • Ignition switch • Throttle lever • Choke (if applicable) • Power-take
PAGE 6
Notes:
PAGE 7
Notes:
PAGE 8