Setup Instructions

ManualsBrandsToro ManualsLawn TractorsToro 74570

Printed in the USA

 2001 by The Toro Company

8111 Lyndale Avenue South

Bloomington, MN 55420-1196

170-DH and 190-DH

Lawn Tractor

Model No. 74570—Serial No. 220000001 and Up

Model No. 74590—Serial No. 220000001 and Up

Form No. 3327-598

Installation Instructions

Loose Parts

Note: Use the chart below to verify all parts have been shipped.

Description Qty. Use

Steering Wheel

Lock washer

Nut

Install the steering wheel.

Seat

Bolt

Flat Washer

Spring Washer

Install the seat.

Trailer Hitch

Bolt

Washer

Nut

Attach the trailer hitch.

Collector Cover

Grass Collector—Partially Assembled

Grass Bag

Fastener Package

Arrow Decal

Assemble the grass collector.

Key 2 Used in the ignition and Key Choice switch.

Operator’s Manual

Engine Operator’s Manual

Read before operating tractor.

Installing the Steering Wheel

1. Position the front wheels straight ahead.

2. Remove the logo cover by releasing the 3 latches from

the back side with a screwdriver.

3. Line up the center spoke toward the seat and position

the steering wheel onto the shaft spline (Fig. 1).

4. Secure the steering wheel with a lockwasher and nut

(Fig. 1).

5. Torque the steering wheel nut to 50 ft-lb. (37 N

m).

6. Snap the logo cover into place (Fig. 1).

Summary of content (4 pages)

PAGE 1
Form No. 3327-598 170-DH and 190-DH Lawn Tractor Model No. 74570—Serial No. 220000001 and Up Model No. 74590—Serial No. 220000001 and Up Installation Instructions Loose Parts Note: Use the chart below to verify all parts have been shipped. Description Qty.
PAGE 2
Attaching the Trailer Hitch 5 1 1. Line up the holes in the trailer hitch with the holes in the tractor frame. 3 2. Attach the hitch with two bolts, washers, and nuts (Fig. 3). 4 2 1 2307 Figure 1 1. Center spoke 2. Shaft spline 3. Lock washer 4. Nut 5. Logo cover 2 Installing the Seat 1. Remove the plastic cover from the seat and discard it. 3 2. Loosen the two bolts on the tractor seat hinges. Figure 3 3.
PAGE 3
11. Insert the dumping lever through the hole of the cover and secure it with the M5 x 12 screw and M5 nut (inside the tube) (Fig. 4). 11 1 12. Install the grass collector to the tractor (refer to the Operator’s Manual, Installing the Grass Collector). When the grass collector is properly positioned, place the triangle symbol decal directly opposite the triangle symbol on the rear of the tractor.
PAGE 4
5. Install the battery in the chassis; refer to the Operator’s Manual, Installing the Battery. Filling the Fuel Tank Add fuel to the fuel tank; refer to Filling the Fuel Tank in the Operator’s Manual. Checking the Tire Pressure Check front and rear tires for proper inflation; refer to the Operator’s Manual, Tire Pressure for recommended inflation pressure. Lubrication Make sure all of the necessary points on the tractor are lubricated; refer to Greasing and Lubrication in the Operator’s Manual.