Setup Instructions

ManualsBrandsToro ManualsLawn TractorsToro 74582

 2004—The Toro Company

8111 Lyndale Ave., Bloomington, MN 55420, USA

Printed in the USA

Original Instructions (EN)

DH 200, DH 210, and DH 220 Lawn Tractors

Model No. 74573—Serial No. 270000001 and Up

Model No. 74582—Serial No. 270000001 and Up

Model No. 74592—Serial No. 270000001 and Up

Form No. 3357-829 Rev A

Setup Instructions

Loose Parts

Note: Use the chart below to verify all parts have been shipped.

Description Qty. Use

Steering Wheel

Lock washer

Nut

Installing the steering wheel

Seat

Bolts

Flat Washers

Spring Washers

Installing the seat

Trailer Hitch

Bolts

Nuts

Attaching the trailer hitch

Collector Cover

Grass Collector—Partially Assembled

Grass Bag

Fastener Package

Arrow Decal

Assembling the grass collector

Keys 2 Using in the ignition and Key Choice™ switch

Operator’s Manual

Engine Operator’s Manual

Reading before operating the tractor

Summary of content (4 pages)

PAGE 1
Form No. 3357-829 Rev A DH 200, DH 210, and DH 220 Lawn Tractors Model No. 74573—Serial No. 270000001 and Up Model No. 74582—Serial No. 270000001 and Up Model No. 74592—Serial No. 270000001 and Up Setup Instructions Loose Parts Note: Use the chart below to verify all parts have been shipped. Description Qty.
PAGE 2
Installing the Steering Wheel Installing the Seat 1. Position the front wheels straight ahead. 1. Remove the plastic cover from the seat and discard it. 2. Remove the logo cover by releasing the 3 latches from the back side with a screwdriver. 2. Loosen the two bolts on the tractor seat hinges. 3. Set the seat in place and secure it with the two bolts, spring washers, and flat washers (Fig. 2). 3. Line up the center spoke toward the seat and position the steering wheel onto the shaft spline (Fig. 1).
PAGE 3
Attaching the Trailer Hitch 6. Insert the bottom tube into the bag (Fig. 4). 1. Line up the holes in the trailer hitch with the holes in the tractor frame. 11 1 2. Attach the hitch with two bolts and nuts (Fig. 3). 1 10 2 2 3 12 Figure 3 1. Trailer hitch 2. Bolt 3. Nut 4 3 7 4 Assembling the Grass Collector 5 6 8 9 Figure 4 1. 2. 3. 4. 5. 6. 1. Tilt the front tube of the partially assembled collector. 2. Align the upper holes with the holes on the upper tube.
PAGE 4
14. Tighten the rear tractor support bolts. Warning 15. Remove the grass collector from the tractor. 16. Tighten all screws securely. Charging the battery produces gasses that can explode. 17. Use the plastic extrusions on the bag edges to fix the bag to the frame tube. Never smoke near the battery and keep sparks and flames away from the battery. 18. Insert the dumping lever through the hole of the cover and secure it with the M5 x 12 screw and M5 nut (inside the tube) (Fig. 4). 6.