Setup Instructions

FormNo.3367-986RevC

TimeCutter

RidingMowers

ModelNo.Allmodels

SetupInstructions

Setup

LooseParts

Usethechartbelowtoverifythatallpartshavebeenshipped.

ProcedureDescription

Qty.

Use

Nopartsrequired

–

Connectthebattery.

Nopartsrequired

–

Setupthemotioncontrollevers.

Nopartsrequired

–

Connecttheseatholdbar.

Nopartsrequired

–

Checkthemoweradjustment.

IgnitionKey1

Hosecoupling(notincludedinCE

models)

Operator'sManual

EngineOperator'sManual

OperatorTrainingMaterial

CompletetheSetup.

Note:Determinetheleftandrightsidesofthemachinefromthenormaloperatingposition.

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.Toro.com.

OriginalInstructions(EN)

PrintedintheUSA.

AllRightsReserved

PAGE 1
Form No. 3367-986 Rev C TimeCutter® Riding Mowers Model No. All models Setup Instructions Setup Loose Parts Use the chart below to verify that all parts have been shipped. Procedure 1 2 3 4 5 Description Use Qty. No parts required – Connect the battery. No parts required – Set up the motion control levers. No parts required – Connect the seat hold bar. No parts required – Check the mower adjustment.
PAGE 2
. Remove the upper bolt (3/8 x 1 inch) and washer; loosen the lower bolt (3/8 x 1 inch). Raise the motion control levers to the upright position. 1 3. Align the holes in the motion control lever with the holes in the control arm shaft and install the bolt and washer removed previously. Hand tighten all fasteners. Repeat this for both controls levers. Connecting the Battery No Parts Required 4. Move the motion control levers to the park position and raise the seat.
PAGE 3
4 5 Checking the Mower Adjustment Completing the Setup Parts needed for this procedure: No Parts Required Procedure Adjust the side-to-side level and the front-to-rear blade slope. Use the relevant procedures in the Operator's Manual to verify the deck is level and make any adjustments as necessary. Refer to the Operator's Manual for more information.
PAGE 4