Service Manual

9-26
Table of Contents
Twin Cylinder Engine Service Manual
February 2017 - Digital Edition
ENGINE ASSEMBLY
Assemble Upper End (Cont.)
Dipstick Tube (Voltage Regulator Mounted)
1. Install the voltage regulator to the dipstick tube if previously removed (Figure 27).
2. Torque the voltage regulator/dipstick tube bolts to 62 in-lbs. (7 Nm).
3. Install new o-ring on dipstick tube.
4. Loosely install the dipstick tube assembly into the engine block.
5. Orient the wire harness and engine harness plug around the dipstick tube, between it and the engine block.
6. Mount the ground wire with bolt to the sump cover.
7. Torque the harness ground bolt to 89 in-lbs. (10 Nm).
NOTE: If the complete voltage regulator with the wire harness was removed, anchor the harness to the
intake manifold with four plastic ties, see “Intake Manifold with Engine Wire Harness and Voltage
Regulator,” chapter 9, page 9-25 for location of terminals and tie anchors.
Figure 27