Setup Instructions

ManualsBrandsToro ManualsRiding EquipmentToro 74704

 2004 by The Toro Company

8111 Lyndale Avenue South

Bloomington, MN 55420-1196

Printed in the USA

Original Instructions (EN)

TimeCutter



ZX Riding Mowers

Form No. 3328-454 Rev A

Setup Instructions

Note: If needed, a Decal Kit, 106–6412, and French manual are available for the customer. Order the Decal Kit from the Toro

Parts Department and the French manual from either the Toro Parts Department or online at www.toro.com.

Loose Parts

Note: Use the chart below to verify that all parts have been shipped.

Description Qty. Use

Bolt, 1/4 x 3/4 inch

Washer, 1/4 inch

Nut, 1/4 inch

Installing the battery

Seat

Spacer

Knob

Flat washer, 5/16 inch

Installing the seat

Left-hand control lever

Right-hand control lever

Bolt, 3/8 x 1 inch

Curved washer, 3/8 inch

Installing the motion control levers

Hose coupling 1 Washing the underside of the mower

Key 1

Operator’s Manual

Engine Operator’s Manual

Read before operating the machine.

Registration card 1 Fill out and return to Toro.

CALIFORNIA

Proposition 65 Warning

Battery posts, terminals, and related accessories

contain lead and lead compounds, chemicals

known to the State of California to cause cancer

and reproductive harm. Wash hands after

handling.

Warning

Summary of content (4 pages)

PAGE 1
TimeCutter Form No. 3328-454 Rev A ZX Riding Mowers Setup Instructions Note: If needed, a Decal Kit, 106–6412, and French manual are available for the customer. Order the Decal Kit from the Toro Parts Department and the French manual from either the Toro Parts Department or online at www.toro.com. Loose Parts Note: Use the chart below to verify that all parts have been shipped. Description Qty.
PAGE 2
Installing the Battery 4. Wait five to ten minutes after filling the battery cells. Add electrolyte, if necessary, until the electrolyte level is up to the Upper line (Fig. 1) on the battery case. Bulk electrolyte with 1.260 specific gravity must be purchased from a local battery supply outlet. 5. Install the battery vent caps. 6. Charge the battery for 1 hour at 25 to 30 amps or 6 hours at 4 to 6 amps (Fig. 2). Do not overcharge the battery.
PAGE 3
2. Place the levers (with the mounting plates toward the rear of the machine) on the outside of the control arm shaft and loosely secure them with the 4 bolts and curved washers removed in step 1 (Fig. 3). 2. Remove the knobs and flat washers (5/16 inch) from the seat support. 3. Remove the spacers between the seat and seat support. 4. Raise the seat support on the machine (Fig. 5). 1 5. Slide the shoulder bolts on the bottom of the seat into the slots on the seat support (Fig. 5). 6.
PAGE 4
Washing the Underside of the Mower A hose coupling is included in loose parts for washing the underside of the mower. See the Operator’s Manual for the proper procedure. Checking the Mower Adjustment The mower deck was leveled at the factory. If the mower is not cutting level, adjust the side-to-side level and the front-to-rear blade slope. See the Operator’s Manual for the proper procedure.