Instructions / Assembly

FormNo.3388-201RevC

TimeCutter

RidingMowers

ForAllTimeCutter

RidingMowers

SetupInstructions

Setup

LooseParts

Usethechartbelowtoverifythatallpartshavebeenshipped.

ProcedureDescription

Qty.

Use

Nopartsrequired

–

Connectthebattery.

Rearhitch1

Bolt(5/16x1inch)

Locknut(5/16inch)

Installtherearhitch.

Nopartsrequired

–

Setupthemotion-controllevers.

Nopartsrequired

–

Checkthemoweradjustment.

Ignitionkey1

Hosecoupling(notincludedwithCE

models)

Operator'sManual

Engineowner’smanual(non-Toro

engines)

Operatortrainingmaterial

CompletingtheSetup

Note:Determinetheleftandrightsidesofthemachinefromthenormaloperatingposition.

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.T oro.com.

OriginalInstructions(EN)

PrintedintheUSA.

AllRightsReserved

*3388-201*C

PAGE 1
Form No. 3388-201 Rev C TimeCutter® Riding Mowers For All TimeCutter® Riding Mowers Setup Instructions Setup Loose Parts Use the chart below to verify that all parts have been shipped. Procedure Description Use Qty. 1 No parts required – Connect the battery. 2 Rear hitch Bolt (5/16 x 1 inch) Locknut (5/16 inch) 1 2 2 Install the rear hitch. No parts required – Set up the motion-control levers. No parts required – Check the mower adjustment.
PAGE 2
1 2 Connecting the Battery Installing the Rear Hitch No Parts Required Parts needed for this procedure: Procedure WARNING CALIFORNIA Proposition 65 Warning Battery posts, terminals, and related accessories contain lead and lead compounds, chemicals known to the State of California to cause cancer and reproductive harm. Wash hands after handling. 1 Rear hitch 2 Bolt (5/16 x 1 inch) 2 Locknut (5/16 inch) Procedure Install the bracket to the frame as shown in Figure 2 and Figure 3. 1 1.
PAGE 3
5 Setting Up the Motion-Control Levers Completeing the Setup Parts needed for this procedure: No Parts Required Procedure 1. Locate the motion-control levers attached, but folded down on the machine. 2. Remove the upper bolt (3/8 x 1 inch) and washer; loosen the lower bolt (3/8 x 1 inch). 1 Ignition key 1 Hose coupling (not included with CE models) 1 Operator's Manual 1 Engine owner’s manual (non-Toro engines) 1 Operator training material Checking the Tire Pressure 3.
PAGE 4