Setup Instructions

ManualsBrandsToro ManualsOutdoor Power EquipmentTimeCutter MX5025 50 in. Fab 23 HP Kawasaki V-Twin Gas Dual Hydrostatic Zero-Turn Riding Mower with Smart Speed - CARB

FormNo.3417-675RevB

TimeCutter

RidingMowers

ForAllTimeCutter

RidingMowers

Setup

LooseParts

Usethechartbelowtoverifythatallpartshavebeenshipped.

ProcedureDescription

Qty.

Use

Backcushion1

Flanged-hexbolt3

Installthebackcushion(machineswith

a60-inchdeckshippedinasteelcrate

only).

Nopartsrequired

–

Connectthebattery.

Rearhitch1

Bolt(5/16x1inch)

Locknut(5/16inch)

Installtherearhitch.

Nopartsrequired

–

Setupthemotion-controllevers.

Nopartsrequired

–

Checkthemoweradjustment.

Key1

Hosecoupling(notincludedwithCE

models)

Operator'sManual

Engineowner’smanual(non-Toro

engines)

Operatortrainingmaterial

Completingthesetup.

Note:Determinetheleftandrightsidesofthemachinefromthenormaloperatingposition.

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.T oro.com.

OriginalInstructions(EN)

PrintedintheUSA

AllRightsReserved

*3417-675*B

Summary of content (4 pages)

PAGE 1
Form No. 3417-675 Rev B TimeCutter® Riding Mowers For All TimeCutter® Riding Mowers Setup Loose Parts Use the chart below to verify that all parts have been shipped. Procedure Qty. Use Back cushion 1 Flanged-hex bolt 3 Install the back cushion (machines with a 60-inch deck shipped in a steel crate only). 2 No parts required – Connect the battery. 3 Rear hitch Bolt (5/16 x 1 inch) Locknut (5/16 inch) 1 2 2 Install the rear hitch. No parts required – Set up the motion-control levers.
PAGE 2
1 2 Installing the Back Cushion Connecting the Battery Machines with a 60-Inch Deck Shipped in a Steel Crate Only No Parts Required Procedure Parts needed for this procedure: 1 Back cushion 3 Flanged-hex bolt Procedure 1. Lift up the seat onto the springs. 2. Install the back cushion using the 3 flanged-hex bolts (Figure 1). 1. Locate the battery and negative battery cable. 2. Remove the plastic cap from the negative battery post. 3.
PAGE 3
4 Installing the Rear Hitch Setting Up the Motion-Control Levers Parts needed for this procedure: 1 Rear hitch 2 Bolt (5/16 x 1 inch) 2 Locknut (5/16 inch) No Parts Required Procedure 1. Locate the motion-control levers attached, but folded down on the machine. 2. Remove the upper bolt (3/8 x 1 inch) and washer; loosen the lower bolt (3/8 x 1 inch). 3. Raise the motion control levers to the upright position. 4.
PAGE 4
6 Completing the Setup Parts needed for this procedure: 1 Key 1 Hose coupling (not included with CE models) 1 Operator's Manual 1 Engine owner’s manual (non-Toro engines) 1 Operator training material Checking the Tire Pressure Check the front and rear tires for proper inflation; refer to Checking the Tire Pressure in the Operator’s Manual for the recommended inflation pressure.