Service Manual

44” MOWER DECKS

TimeCutter



Z Service Manual 6 - 11

9. Install the belt covers over the outside spindles.

Figure 108

m-7263

Removing the Mower

Note: Before removing the mower, make a note for

which holes are used in the leveling brackets (Figure

110).

1. Park the machine on a level surface and

disengage the blade control (PTO).

2. Move the motion control levers to the brake

position, stop the engine, remove the key, and

wait for all moving parts to stop before leaving the

operating position.

3. Lower the height-of-cut lever to the lowest

position.

4. Remove the hairpin cotter and clevis pin from the

front support rod on each side of the mower

(Figure 109).

Figure 109

m-6431

5. Remove the hairpin cotter and washer from the

adjusting rod (Figure 110) on each side of the

mower.

(1) Mower belt

(2) Idler arm

(3) Outside pulley

(4) Spring

(5) Engine pulley

(6) Belt cover

(7) Belt guide

(1) Hairpin cotter and clevis pin (2) Support rod