Service Manual

7-19
Table of Contents
Disassembly
Twin Cylinder Engine Service Manual
February 2017 - Digital Edition
ENGINE DISASSEMBLY
Disassembly Upper End (Cont.)
Carburetor (Cont.)
3. Disconnect the fuel solenoid wire at the wire harness plug located near the #1 cylinder port of the intake
manifold. Carefully remove the plug from between the intake manifold and the cylinder block (Figure 21).
4. Slide the carburetor with the fuel solenoid off the mounting studs.
5. Remove any remaining gaskets and the insulator. Retain the insulator, discard the gaskets.
NOTE: The two-barrel carburetor function, analysis, and rebuild details are in chapter 3, section 3-1.
Figure 21