Service Manual
9-37
Table of Contents
Reassembly
Twin Cylinder Engine Service Manual
February 2017 - Digital Edition
ENGINE ASSEMBLY
Assemble Upper End (Cont.)
Engine Shrouds
1. Install the cylinder #2 plastic shroud.
2. Install the oil drain hose cleat if previously removed.
3. Torque the oil drain hose cleat bolts to 62 in-lbs. (7 Nm).
4. Loosely install the two longer shoulder bolts to the upper mount.
5. Install the short shoulder bolt to the underside of the head.
6. Torque the shroud mount bolts to 89 in-lbs. (10 Nm).
7. Install the cylinder #1 plastic shroud.
8. Install the fuel pump assembly if previously removed.
9. Torque the fuel pump mounting bolts to 62 in-lbs. (7 Nm).
10. Loosely install two longer shoulder bolts to the upper mount.
11. Install the shoulder bolt to the underside of the head.
12. Torque the shroud mount bolts to 89 in-lbs. (10 Nm).
13. Connect the fuel supply hose from the fuel pump to the top of the carburetor.
14. Connect the vacuum line from the fuel pump to #1 cylinder side of the intake manifold.
15. Loosely install any remaining longer shoulder bolts to retain the blower shroud.
16. Install the blower shroud sliding over the shoulder bolts. The blower shroud mounts between the lower bafe
and dipstick.
NOTE: Do not pinch fuel, vent or vacuum lines when installing blower shroud.
17. While holding the shroud down, tighten the six shoulder bolts starting with the bolts on each side of the air
lter.
18. Torque the six blower shroud shoulder bolts to 89 in-lbs. (10 Nm).
19. Weave the oil drain hose onto the cleat.