Service Manual

3-12
Table of Contents
Twin Cylinder Engine Service Manual
February 2017 - Digital Edition
TWO BARREL CARBURETOR AND FUEL SYSTEM
Disassembly (Cont.)
Float Bowl and Gaskets
NOTE: The oat bowl is a shared chamber for both main jet nozzles. The fuel solenoid and the bowl drain
bolt mount to the oat bowl.
The main nozzles are sealed with an o-ring gasket (I) (Figure 9) that ts into the oat bowl. The bowl gasket (H) is
an o-ring gasket that ts into a groove of the oat bowl (J).
1. Remove the four screws and oat bowl.
NOTE: Use a small clamping pliers to initially loosen the screws.
2. Remove and inspect the o-ring gaskets for cuts or damage, then discard. An example of damaged o-ring
gaskets is shown below (Figure 10).
Figure 9
H
I
J
Figure 10