Service Manual

3-24
Table of Contents
Twin Cylinder Engine Service Manual
February 2017 - Digital Edition
TWO BARREL CARBURETOR AND FUEL SYSTEM
Assembly
NOTE: Replace bowl gaskets and oat needle.
NOTE: If choke override was accidentally removed, replace carburetor assembly.
Choke Shaft
1. Insert the spring with the inner end in the short slot of the override assembly, place the other end resting on the
outer edge (Figure 25).
2. Place a drop of motor oil on each bearing surface of the choke shaft.
3. Insert the shaft through the spring and into the override and carburetor while rotating the shaft counter-
clockwise to hook the spring end with the tang (Figure 26).
NOTE: The end of the spring sits against the curve of the tang.
Figure 25
Figure 26