Service Manual

3-27

Table of Contents

Two Barrel Carb./Fuel

Twin Cylinder Engine Service Manual

February 2017 - Digital Edition

TWO BARREL CARBURETOR AND FUEL SYSTEM

Assembly (Cont.)

Throttle Shaft

1. Place a drop of motor oil on each bearing surface of the shaft (Figure 30).

2. Install the spring and guides onto the throttle shaft if previously removed. Place a plastic guide (X) (Figure 30)

on each side of the spring (Y). The long end of the spring is toward the carburetor, the short end hooks over

the tang.

3. Slide the throttle shaft with the spring and bushings into the carburetor body, until only 1 in. of the shaft is

exposed.

Figure 30