Service Manual

5-5
Table of Contents
Electrical
Twin Cylinder Engine Service Manual
February 2017 - Digital Edition
ELECTRICAL SYSTEM AND COMPONENTS
Charging System Testing
NOTE: Use the three stator tests below to determine if the ywheel or stator has failed.
OHM Resistance Test Across the Leads
1. Shut engine off.
2. Set Digital Multi-Meter to OHMs.
3. Connect Digital Multi-Meter leads to stator leads.
NOTE: Unplug from engine harness.
4. Measure the resistance. Expected measurement should be less than one OHM (component at room
temperature).
5. Replace stator if measured resistance is higher than one OHM.
Figure 4