Service Manual

5-6
Table of Contents
Twin Cylinder Engine Service Manual
February 2017 - Digital Edition
ELECTRICAL SYSTEM AND COMPONENTS
Charging System Testing (Cont.)
OHM Resistance Test to Ground
1. Shut off the engine.
2. Set Digital Multi-Meter to OHMs.
3. Connect one Digital Multi-Meter lead to either stator lead.
NOTE: Unplug from engine harness.
4. Connect other Digital Multi-Meter lead to ground (stator frame or engine block if stator mounted to the engine
block).
5. Measure the resistance. Expected measurement should be (high resistance) innity (component at room
temperature).
6. Replace stator if measured resistance is less than innity.