Service Manual
14 ZT-2800
®
/ZT-3100™/ZT-3400™
RefertoFigure8
Disassembly
1. Remove all items previously discussed in
their recommended order.
2. Remove the RTN control arm kit (211) by
rst removing the spring (147) and Torx
head screw (46). The remaining members
of the assembly can be removed as a single
item – washer (146), unidirectional scissor
arm kit (145), and the control arm (44).
3. Remove the Allen head screw (142), washer
(45), neutral arm (141) and spacer (140).
NOTE: Onlyremovetheseal(41)ifdamaged
orworn.ThesealisnotpartoftheRTN
control arm kit (211), and cannot be
servicedseparately.Referto“SealKit”
intheItemsListonpages43or45.
Inspection
1. Inspect all parts for excessive wear or dam-
age. Replace if necessary.
Assembly
1. Reassemble all parts in the reverse order
of disassembly.
2. When tightening the fasteners, refer to the
table on page 21 for the required torque
values.
3. Refer to the RTN adjustments on page
13.
NOTE: Asageneralrule,usethelowendof
the torque specication on fasteners
whenreassemblingtheunit.
RETURN TO NEUTRAL ASSEMBLY
Figure 8, Return to Neutral Assembly
RefeR to “RetuRn to neutRal Setting”
on Page 13.
211
46
146
145
14244
141
45
140
147
41