Service Manual

8-11
Digital Edition - TIMECUTTER® HD Service Manual
April 2017
Table of Contents
MOWER DECK
Deck
Mower Spindle (Cont.)
Disassembly
1. Clamp the spindle for service by placing the spindle shaft in a vise.
2. Remove the nut and washer from the top of the pulley (B) (Figure 11).
3. Remove the pulley (B) (Figure 11).
4. Remove spindle housing from the shaft.
5. Remove the bearing shield (C) (Figure 11).
6. Remove the bearing and the bearing spacer from the top of the spindle housing.
7. Flip over the spindle housing and remove the lower bearing.
8. Inspect the inside of the spindle housing for wear or damage.
A
B
C
D
E
F
G
H
I
Figure 11
A. Spindle Nut
B. Pulley
C. Bearing Shield
D. Spindle Assembly
E. Spindle Mounting Screws
F. Spindle (Apply Anti-Seize)
G. Blade
H. Belleville Washer
I. Blade Bolt