Service Manual

8-16
Digital Edition - TIMECUTTER® HD Service Manual
April 2017
Table of Contents
MOWER DECK
Leveling the Mower Deck (Cont.)
12. Loosen the leveling adjustment bolts (Figure 16) on all four corners so that the deck is sitting squarely on all
four blocks.
13. Remove any slack from the deck hangers and make sure the deck lift foot lever is pushed back against the
stop.
14. Tighten the four leveling adjustment bolts.
15. Re-check that the blocks fit snugly under the deck skirt and that all attachment bolts are tight.
16. Verify that the front to rear blade slope is within tolerance. The front blade tip should be between 1/16 - 5/16
in. (1.6 - 7.9 mm) lower than the rear blade tip to a flat surface.
17. Recheck the level of the blades and repeat deck leveling procedure if necessary.
Servicing the Cutting Blades
See “Servicing the Cutting Blades,” chapter 3, page 3-16.
A
A
B
B
C
C
D
D
Figure 16
A. Deck-Lift Arm
B. Chain
C. Hook
D. Adjustment Bolt