Manualshelf

Service Manual

ManualsBrandsToro ManualsOutdoor Power EquipmentTimeCutter MX6050 60 in. Fab 24.5 HP V-Twin Gas Zero-Turn Riding Mower with Smart Speed
51525354555657585960
5-12
Digital Edition - TIMECUTTER® HD Service Manual
April 2017
Table of Contents
CHASSIS
Seat - TIMECUTTER® HD ZX Models Only (Cont.)
Installation
1. Verify that the fuel tank hold down is seated properly in the front and rear of the frame and secured with the
hold down bolt (Figure 12).
2. Place the seat on top of the fuel tank and align the hole in one side of the frame with the hole in the seat plate.
3. Install the stop rod and secure with one cotter pin.
4. Slide the rod toward the outside of the machine while aligning the hole on the opposite side with the hole in the
frame.
5. Insert the stop rod to secure the seat in place and install the cotter pin.
6. Raise the seat and connect the wire harness terminal to the operator presence switch.
7. Lift and lower the seat to verify proper function of the seat pivots and the seat latch.
8. Connect the battery terminals.
9. Verify proper function of the unit.
Figure 12