Service Manual

9-27
Table of Contents
Reassembly
Twin Cylinder Engine Service Manual
February 2017 - Digital Edition
ENGINE ASSEMBLY
Assemble Upper End (Cont.)
Stator (Alternator)
1. Install the stator with the wire harness toward the dipstick tube and engine block (Figure 28).
2. Secure stator with the four bolts.
3. Torque the stator charging coil bolts to 89 in-lbs. (10 Nm).
4. Route the stator wire between the dipstick tube and engine block, slide the harness into the retainer on the
dipstick tube.
5. Connect the stator wire terminals to the voltage regulator wire harness terminals (orientation doesn’t matter).
Figure 28