Service Manual

9-31
Table of Contents
Reassembly
Twin Cylinder Engine Service Manual
February 2017 - Digital Edition
ENGINE ASSEMBLY
Assemble Upper End (Cont.)
Ignition Coils
1. Install the ground wire to male terminal on ignition coil (Figure 33).
2. Install the ignition coil and loosely mount with two screws.
3. Rotate the ywheel to align magnets to ignition coil.
4. Using proper thickness gauge, tighten the ignition coil screws. Ignition coil air gap is 0.011 in. (0.3 mm).
NOTE: Use caution as the magnet will strongly pull the ignition coil to the ywheel.
5. Torque the ignition coil bolts to 89 in-lbs. (10 Nm).
6. Repeat for other coil.
NOTE: To prevent accidental starting, do not install spark plug boots onto the spark plugs.
Figure 33