Service Manual

3-33
Table of Contents
Two Barrel Carb./Fuel
Twin Cylinder Engine Service Manual
February 2017 - Digital Edition
TWO BARREL CARBURETOR AND FUEL SYSTEM
Assembly (Cont.)
Float Bowl and Gaskets
1. Install a new o-ring gasket in the oat bowl for the main nozzle (Figure 38).
2. Install a new bowl o-ring gasket onto the oat bowl.
3. Align the two pins of the oat bowl to the two holes in the carburetor body (Figure 39).
4. While holding the bowl to the carburetor body, use ngers to tighten the four screws.
5. Use a Phillips screwdriver in a crisscross pattern for the nal tightening.
6. If previously removed, install new gasket onto drain screw, then install onto the oat bowl.
Figure 38
Figure 39
A
B
A. Float Bowl O-Ring Gasket B. Main Nozzle O-Ring Gasket