Service Manual

HYDRO-GEAR TRANSAXLE

4 - 4 TimeCutter



Z Service Manual

9. Slowly lower the hydro frame and the transaxles

down about half way out of the frame of the unit

and stop.

Figure 35

mvc-114

10. Disconnect both the right and left hydro rods by

removing the bolt and nut through the frame of the

unit (Figure 36).

Figure 36

mvc-115

11. Lift up on the front of the hydro frame and move

the hydro mount frame toward the rear end of the

unit. Use caution not to bend the right and left

brake rods and the hydro rods (Figure 36).

12. Hydro mount frame and the two transaxles

removed from the frame of the unit (Figure 37).

Figure 37

mvc-105

Removing Transaxles from the

Hydro Mount Frame

1. Remove the bolt and nut retaining bypass arm to

the bypass lever and remove the arm off the hydro

frame (Figure 38).

Figure 38

mvc-106