Service Manual

9-25
Table of Contents
Reassembly
Twin Cylinder Engine Service Manual
February 2017 - Digital Edition
ENGINE ASSEMBLY
Assemble Upper End (Cont.)
Intake Manifold with Engine Wire Harness and Voltage Regulator
NOTE: If replacing the intake manifold only, see “Dipstick Tube (Voltage Regulator Mounted),” chapter
9, page 26 step for voltage regulator and wire harness installation, wire harness placement and
anchor locations on the manifold (Figure 25).
1. Lay out the wire harness and intake manifold onto the top of the engine block with the voltage regulator and
harness plug near the dipstick mounting.
2. Using new gaskets, mount the intake manifold to each head with two bolts per head (Figure 26).
NOTE: #2 cylinder mounting bolt, closest to carburetor, has the wire harness ground terminal.
3. Torque bolts to 89 in-lbs. (10 Nm) in two passes:
-1st pass 44 in-lbs. (5 Nm)
-2nd pass 89 in-lbs. (10 Nm)
Figure 25
Figure 26