Service Manual
3-33
Table of Contents
Two Barrel Carb./Fuel
Twin Cylinder Engine Service Manual
February 2017 - Digital Edition
TWO BARREL CARBURETOR AND FUEL SYSTEM
Assembly (Cont.)
Float Bowl and Gaskets
1. Install a new o-ring gasket in the oat bowl for the main nozzle (Figure 38).
2. Install a new bowl o-ring gasket onto the oat bowl.
3. Align the two pins of the oat bowl to the two holes in the carburetor body (Figure 39).
4. While holding the bowl to the carburetor body, use ngers to tighten the four screws.
5. Use a Phillips screwdriver in a crisscross pattern for the nal tightening.
6. If previously removed, install new gasket onto drain screw, then install onto the oat bowl.
Figure 38
Figure 39
A
B
A. Float Bowl O-Ring Gasket B. Main Nozzle O-Ring Gasket