Service Manual

5-7
Table of Contents
Electrical
Twin Cylinder Engine Service Manual
February 2017 - Digital Edition
ELECTRICAL SYSTEM AND COMPONENTS
Charging System Testing (Cont.)
AC Volts Output at Leads
1. Engine running at Top No-Load RPM (3300 RPM).
2. Set Digital Multi-Meter to AC volts.
3. Connect both Digital Multi-Meter leads to each stator lead.
4. Measured AC volts. Expected reading should be minimum of 30 VAC at top no-load RPM.
5. If measure voltage is below 30 volts AC, inspect ywheel for broken or cracked magnets.
6. Replace ywheel if magnets are damaged.
7. Repeat step 4.
8. If measured voltage is still below 30 volts AC replace stator.