Service Manual

24 ZT-2200 (EZT
®
)
Figure 14. Motor Shaft
Refer to Figure 14.
Disassembly
1. Remove the control arm and bypass arm.
See page 18.
2. Drain the oil from the transaxle. See page
11.
3. Remove the side cover. See page 22.
4. Remove the reduction gears. See page
23.
5. Remove at washer (36), motor shaft and
pinion gear (39 & 38) and at washer (40).
Inspection
1. Inspect the motor shaft (39), pinnion gear
(38) and at washers (36 & 40) for wear or
damage.
Assembly
1. Insert the motor shaft (39) with the pinnion
gear (38) and at washers (36 & 40) into the
center section (57).
2. Install the reduction gears. See page 23.
3. Install the side cover. Refer to page 22.
4. Install new seals. Refer to page 19.
5. Fill the transaxle with oil. See page 11.
6. Install the bypass arm and control arm. See
page 18.
MOTOR SHAFT