Service Manual

30 ZT-2200 (EZT
®
)
Figure 24.
Use the following procedure to complete the
installation of the transaxle on the vehicle.
1. Install and secure the transaxle on the
vehicle according to the instructions in the
vehicle owner’s manual.
2. With the vehicle raised, install the wheels
on the axles, and snug the wheel hard-
ware.
3. Lower the vehicle wheels to the ground
and torque the wheel hardware per the
vehicle owner’s manual.
Figure 25.
TRANSAXLE INSTALLATION
1
4
38
39
57
19
6
If the unit has been torn down completely, the
following summary identies the assembly pro-
cedures necessary to completely assemble the
unit. Each assembly procedure is located by a
page reference.
The part reference numbers provided in each
assembly procedure are keyed to the individual
exploded views, and are also keyed to the com-
plete unit exploded view on page 32.
1. Install the hydraulic components. See
pages 26-30.
2. Install the input shaft and bypass rod. See
page 25.
3. Install the axle shaft, reduction gears and
expansion plate. See page 23.
4. Install the cog brake and side cover. See
page 20-22.
5. Fill the transaxle with new oil. See page
11.
6. Install the bypass arm and control arm.
See page 18.
7. Install the transaxle onto the vehicle.
8. Perform the purge procedures listed on
page 12.
ASSEMBLY AFTER A COMPLETE TEARDOWN