Setup Instructions Form No. 3358-267 Rev A Register your product at www.Toro.com TM Titan Z4800 and Z5200 Model No. 74812-Serial No. 270000001 and Up Model No. 74814-Serial No.
Loose Parts Note: Use the chart below to verify that all loose parts have been shipped. Description Qty Use Warranty Registration Form 1 Fill out and return to Toro Key, Toro Ignition Key, Standard Ignition 1 1 Unit ignition Hose, Connector 1 Manual, Operator’s Manual, Parts DVD, Titan Safety 1 1 1 Manual, Engine Operator’s 1 Read and view before operating machine Servicing the Battery Checking Tire Pressure 1. Check the tire pressure in the drive and front caster tires.
IMPORTANT: Make sure the negative battery cables are disconnected and the battery charger used for charging the battery has an output of 16 volts and 7 amps or less to avoid damaging the battery (see chart below for recommended charger settings). Maximum Charging Charger Interval Settings 16 volts / No Charging 12.6 or greater 100% 7 amps Required 16 volts / 12.4 – 12.6 75 – 100% 30 Minutes 7 amps 16 volts / 1 Hour 12.2 – 12.4 50 – 75% 7 amps 14.4 volts / 2 Hours 12.0 – 12.2 25 – 50% 4 amps 14.4 volts / 11.
Servicing the Engine Installing the Discharge Deflector Engine is shipped with oil; check oil level and if necessary fill to the appropriate level with oil as specified in Engine Owner’s Manual. 1. Install discharge deflector (Figure 6). 2. Servicing the Hydraulic Oil Place the spring on the rod. Slide rod, straight end, through the front discharge deflector bracket, discharge deflector, and rear deflector bracket. 3.
