Addendum

Form No. 3358-317 Rev A

Titan Z4800/5200 Zero-Turn-Radius

Riding Mower

Model No. 74812/74814 —Serial No. 270000001 and Up

Addendum

Note: Deter mine the left and right sides of the mac hine from the nor mal operating position.

T he follo wing procedures for installing and/or

re placing the disc harg e deﬂector supersede the

instr uctions found in the standard documentation

accompanying this mac hine . R etain these

instr uctions with all other documentation for y our

mac hine .

Installing the Discharge

Deector

Parts needed for this step:

Deector assembly

Rod

Spring

Procedure

1. P osition the disc harg e deﬂector assembly with

the brac k et ends betw een the w elded brac k ets

on the dec k as sho wn in Figure 1 .

2. Install the spring onto the straight end of the

rod. P osition the spring on the rod as sho wn

in Figure 1 so the shor ter spring end is coming

from under the rod before the bend and g oing

o v er the rod as it retur ns from the bend.

3. Install the spring and rod assembly through

the openings in both the dec k brac k ets and the

deﬂector brac k et ( Figure 1 ).

G006036

Figure 1

1. Deector assembly

4. Spring

2. Deck brackets 5. Spring installed over the

rod

3. Rod

T his pr ocedur e is contin ued on the other

side of this pa ge.

8111 Lyndale Avenue South

Bloomington, MN 55420

Printed in the USA.

PAGE 1
Form No. 3358-317 Rev A Titan Z4800/5200 Zero-Turn-Radius Riding Mower Model No. 74812/74814—Serial No. 270000001 and Up Addendum Note: Determine the left and right sides of the machine from the normal operating position. The following procedures for installing and/or replacing the discharge deﬂector supersede the instructions found in the standard documentation accompanying this machine. Retain these instructions with all other documentation for your machine.
PAGE 2
Replacing the Discharge Deector 4. Lift the long end of the spring and place it into the notch on the deﬂector assembly bracket (Figure 2). 5. Secure the rod and spring assembly by twisting it so the short end of the rod can be placed behind the front bracket welded to the deck (Figure 2). An uncovered discharge opening could allow the lawn mower to throw objects in the operator’s or bystander’s direction and result in serious injury. Also, contact with the blade could occur.