Service Manual

HYDROSTATIC DRIVE SYSTEM
7-92007 - 2008 Titan Z Service Manual
7
Motion Control Pivot Assembly
Replacement
The following procedures show replacing and servicing
the left hand motion control pivot assembly. The same
procedures can be followed to replace and service the
right hand motion control pivot assembly. Exceptions are
noted within the procedures.
6. Unplug the left neutral switch from the harness (Fig.
389).
5. Remove the two screws and washers retaining the
left hand lever grip assembly from the lever mount
post (Fig. 388).
Motion Control Pivot Removal
1. Raise the seat.
2. Remove the negative and then the positive battery
cable from the battery.
3. Loosen the two wing nuts on the battery hold down
bolts and remove the battery from the unit (Fig. 387).
4. Left Hand Motion Control Pivot: Remove the left
hand fender and fuel tank. Refer to “Left Hand
Fender and Fuel Tank Removal” on page 3-7.
Right hand Motion Control Pivot: Remove the right
hand fender. Refer to “Right Hand Fender Removal”
on page 3-14.
Fig. 387 IMG-0456
Fig. 388 IMG-0523a
Fig. 389 IMG-0522a