Setup Instructions

ManualsBrandsToro ManualsRiding EquipmentToro 74823

FormNo.3360-964RevA

TITANZero-Turn-RadiusRidingMowers

ModelNo.AllModels

SetupInstructions

LooseParts

Usethechartbelowtoverifythatallpartshavebeenshipped.

ProcedureDescription

Qty.

Use

Nopartsrequired

–

Connectthebattery.

Nopartsrequired

–

Setupthemotioncontrolleversandthe

Seat.

IgnitionKey1

Hosecoupling1

Operator’sManual

EngineOperator’sManual

OperatorTrainingMaterial

CompletetheSetup.

Note:Determinetheleftandrightsidesofthemachinefromthenormaloperatingposition.

ConnectingtheBattery

NoPartsRequired

Procedure

1.Locatethebatteryandnegativebatterycableinthe

centerofthemachine.

2.Removetheblackplasticcapfromthenegative

batterypost.Removethefastenersfromthenegative

batterycableandusethemtosecurethenegative

batterycabletothenegativebatterypost(Figure1).

G010257

Figure1

1.Bolt4.Negativebatterypost

2.Washer5.Nut

3.Negativebatterycable

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.Toro.com.

OriginalInstructions(EN)

PrintedintheUSA.

AllRightsReserved

Summary of content (4 pages)

PAGE 1
Form No. 3360-964 Rev A TITAN Zero-Turn-Radius Riding Mowers Model No. All Models Setup Instructions Loose Parts Use the chart below to verify that all parts have been shipped. Procedure 1 2 3 Description Use Qty. No parts required – Connect the battery. No parts required – Set up the motion control levers and the Seat. Ignition Key Hose coupling Operator’s Manual Engine Operator’s Manual Operator Training Material 1 1 1 1 1 Complete the Setup.
PAGE 2
Setting Up the Motion Control Levers and the Seat No Parts Required Procedure 1. Remove the upper bolt (3/8 x 1 inch) and washer; loosen the lower bolt (3/8 x 1 inch) as shown in Figure 2. 2. Align the holes in the motion control lever with the holes in the control arm shaft and install the bolt and washer removed previously (Figure 2). Hand tighten all fasteners. Repeat this for both controls levers. Move the motion control levers into the neutral lock position. G010256 Figure 2 3.
PAGE 3
B. Slide the seat rod out from the brackets and seat frame. C. Rotate the seat 180 degrees and install it into the bracket you removed it from, using the rod and hairpin cotters removed previously. D. Connect the interlock switch cable to the seat. E. Lower the seat into the operating position (Figure 4). F. Move the control levers back to the center position (neutral) as shown in Figure 4. E F G009802 Figure 4 4. Verify the motion control levers are properly aligned (Figure 5). Adjust as necessary.
PAGE 4
3 Completing the Setup Parts needed for this procedure: 1 Ignition Key 1 Hose coupling 1 Operator’s Manual 1 Engine Operator’s Manual 1 Operator Training Material Procedure Checking the Tire Pressure Check the front and rear tires for proper inflation. Refer to Checking the Tire Pressure in the Operator’s Manual for the recommended inflation pressure. Checking the Side Discharge Chute Remove the packing restraint holding the side discharge chute up and lower the chute into place.