Setup Instructions

ManualsBrandsToro ManualsRiding EquipmentToro 74862

FormNo.3382-315RevB

TITAN

RidingMower

ModelNo.AllModels

SetupInstructions

Setup

LooseParts

Usethechartbelowtoverifythatallpartshavebeenshipped.

ProcedureDescription

Qty.

Use

Nopartsrequired

–

Connectthebattery.

Rearhitch1

Bolt(5/16x2-1/2inches)

Locknut(5/16inch)

Installtherearhitch.

Nopartsrequired

–

SetuptheRolloverProtectionSystem

(ROPS)bar.

Nopartsrequired

–

Checkthemoweradjustment.

Ignitionkey1

Hosecoupling(notincludedwithCE

models)

Operator'sManual

Engineoperator'smanual1

Operatortrainingmaterial

Completethesetup.

Note:Determinetheleftandrightsidesofthemachinefromthenormaloperatingposition.

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.Toro.com.

OriginalInstructions(EN)

PrintedintheUSA

AllRightsReserved

*3382-315*B

Summary of content (4 pages)

PAGE 1
Form No. 3382-315 Rev B TITAN® Riding Mower Model No. All Models Setup Instructions Setup Loose Parts Use the chart below to verify that all parts have been shipped. Procedure Description Use Qty. 1 No parts required – Connect the battery. 2 Rear hitch Bolt (5/16 x 2-1/2 inches) Locknut (5/16 inch) 1 2 2 Install the rear hitch. No parts required – Set up the Rollover Protection System (ROPS) bar. No parts required – Check the mower adjustment.
PAGE 2
1 2 Connecting the Battery Installing the Rear Hitch No Parts Required Parts needed for this procedure: Procedure 1. Locate the battery and negative battery cable. 2. Remove the fasteners on the negative battery cable, and use them to secure the negative battery cable to the negative post (Figure 1). 1 2 3 4 1 Rear hitch 2 Bolt (5/16 x 2-1/2 inches) 2 Locknut (5/16 inch) Procedure Use the 2 bolts (5/16 x 2-1/2 inches) to secure the bracket to the frame (Figure 2).
PAGE 3
Setting up the Rollover Protection System (ROPS) Bar No Parts Required Procedure 1. Remove the bolts (1/2 x 3 inches), washers, and nuts from the middle hole on the ROPS plate (Figure 3). Figure 4 Left side shown; repeat on the right side 1. Washer 2. Bolt (1/2 x 3 inches) 3. Fourth hole 4. Nut 5. Install the removed bolts (1/2 x 3 inches), washers, and nuts into the lowest hole in the ROPS plate (Figure 5). Figure 3 Left side shown; repeat on the right side 1. Washer 2. Bolt (1/2 x 3 inches) 3.
PAGE 4
Checking the Mower Adjustment No Parts Required Procedure Adjust the side-to-side level and the front-to-rear blade slope. Use the relevant procedures in the Operator's Manual to verify that the deck is level, and make any adjustments as necessary. Refer to the Operator's Manual for more information.