Reference Guide

ManualsBrandsToro ManualsRiding EquipmentToro 74949

Revision 1 03-01-2021 Toro Form No 3445-725 Rev A

Tool Inspection Process

Check the operating hours on the hour meter, then perform the necessary maintenance procedures as specified in the following table (for complete

procedures, refer to the Operator’s Manual):

Maintenance Service Interval

Maintenance Procedure

Before each use or daily. • Check the safety-interlock system.

• Check the engine-oil level

• Check the seat belt.

• Check the roll-bar knobs.

• Clean the engine screen and the oil cooler.

• Check and clean the hydraulic-unit shrouds.

• Inspect the blades.

• Clean the mower deck.

After the first 100 hours • Check the wheel lug-nut torque.

• Check the wheel-hub slotted-nut torque.

• Check the parking-brake adjustment.

After the first 250 hours • Change the hydraulic filters and hydraulic fluid.

Tool Rental Center

Tool Turn Guide

Z Master Commercial 3000 Series Riding Mower

Model No. 74949—400000000 and Up

Model No. 74949HD—400000000 and Up

Supplier Technical Support #:

800-888-9926 (US and Canada)

Supplier Website: www.Toro.com

PURPOSE

Follow the directions below to maintain this tool.

SAFETY

Shut off the engine, remove the key, wait for all movement to stop, and allow the machine to cool

before adjusting, repairing, cleaning, or storing it.

Refer to the product Operator’s Manual for complete safety information.

Summary of content (4 pages)

PAGE 1
Tool Turn Guide Tool Rental Center Z Master Commercial 3000 Series Riding Mower Model No. 74949—400000000 and Up Model No. 74949HD—400000000 and Up Supplier Technical Support #: 800-888-9926 (US and Canada) Supplier Website: www.Toro.com PURPOSE Follow the directions below to maintain this tool. SAFETY Shut off the engine, remove the key, wait for all movement to stop, and allow the machine to cool before adjusting, repairing, cleaning, or storing it.
PAGE 2
Maintenance Service Interval Maintenance Procedure Every 50 hours • Check the spark arrestor (if equipped). • Check the tire pressure. • Inspect the belts for cracks and wear. • Check the hydraulic-fluid level. Every 100 hours • Lubricate the mower deck-lift pivots. • Change the engine oil. • Replace or clean and gap the spark plug. • Check and clean the engine-cooling fins and shrouds. Every 200 hours • Change the engine-oil filter.
PAGE 3
Spring Maintenance Guide Tool Rental Center PURPOSE Z Master Commercial 3000 Series Riding Mower Model No. 74949—400000000 and Up Model No. 74949HD—400000000 and Up Supplier Technical Support #: 800-888-9926 (US and Canada) Supplier Website: www.Toro.com Follow the directions below to maintain this tool. SAFETY Refer to the product Operator’s Manual for complete safety information.
PAGE 4
10 Check that the tire pressure is 90 kPa (13 psi). 11 Check the parking brake. 12 Check the deck leveling. Recommended Routine Maintenance: Step Action 1 Charge the battery. 2 Change the engine oil and filter. 3 Change the hydraulic fluid and filters. 4 Change the fuel filter. 5 Replace the primary and secondary air filters. 6 Replace the spark plugs. 7 Replace or sharpen the mower blades. 8 Torque the wheel lug nuts to 122 to 129 N∙m (90 to 95 ft-lb).