Service Manual

10 ZT-2800
®
/ZT-3100™/ZT-3400™
FILTER AND FILTER GUARD
RefertoFigure4
Disassembly
1. Remove the hex head screws (105), and
lter guard (106).
2. Remove the lter (23) and discard.
NOTE: Alwaysreplacethelterwhenperform-
ing any internal maintenance to the
transaxle.
3. Remove the metal oil drain plug (5) or the
tting (111) from inlet port and allow any
remaining oil to drain from the transaxle.
Inspection
1. Inspect all parts for excessive wear or dam-
age. Replace if necessary.
Assembly
1. Reassemble all parts in the reverse order
of disassembly.
2. When tightening the fasteners, refer to the
table on page 21 for the required torque
values.
3. Fill transaxle with oil. Refer to “Fluid Change
Procedures,” page 11, steps 3 and 4 for lter
change instructions.
NOTE: Asageneralrule,usethelowendof
the torque specication on fasteners
whenreassemblingtheunit.
Figure 4, Filter and Guard
Whenrellingthetransaxlewithoil,
removetheportplug(5),ifinstalled,
andplug(11).Filluntiltheoilreachesthe
lowerlipofport(11)onsidecover.
23
106
105
111
5
11
Unitswillhaveinstalled,thetting(111)
ortheplug(5).
Drain port
(for horizontal installation)