Setup Instructions

ManualsBrandsToro ManualsOutdoor Power EquipmentTimeCutter HD with MyRIDE 54 in. Fab 24.5 HP V-Twin Gas Zero-Turn Riding Mower with Smart Speed

FormNo.3410-234RevC

TimeCutter

HDRidingMower

ForAllTimeCutter

HDRidingMowers

Setup

LooseParts

Usethechartbelowtoverifythatallpartshavebeenshipped.

ProcedureDescription

Qty.

Use

Nopartsrequired

–

Connectthebattery.

Rearhitch1

Bolt(5/16x1inch)

Locknut(5/16inch)

Installtherearhitch.

Nopartsrequired

–

Setupthemotion-controllevers(CE

machinesonly).

Nopartsrequired

–

Checkthemoweradjustment.

Ignitionkey1

Hosecoupling(non-CEmachinesonly)

Operator'sManual

Engineowner’smanual(non-Toro

enginesonly)

Operatortrainingmaterial

Completethesetup.

Note:Determinetheleftandrightsidesofthemachinefromthenormaloperatingposition.

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.Toro.com.

OriginalInstructions(EN)

PrintedintheUSA

AllRightsReserved

*3410-234*C

Summary of content (4 pages)

PAGE 1
Form No. 3410-234 Rev C TimeCutter® HD Riding Mower For All TimeCutter® HD Riding Mowers Setup Loose Parts Use the chart below to verify that all parts have been shipped. Procedure Description Qty. Use 1 No parts required – Connect the battery. 2 Rear hitch Bolt (5/16 x 1 inch) Locknut (5/16 inch) 1 2 2 Install the rear hitch. No parts required – Set up the motion-control levers (CE machines only). No parts required – Check the mower adjustment.
PAGE 2
1 Connecting the Battery No Parts Required Procedure 1. Loosen the 2 fasteners on the battery cover counterclockwise 1/4 turn and remove the battery cover (Figure 1). g197768 Figure 2 g190587 Figure 1 2. Remove the plastic cap from the negative battery post. 3. Remove the fasteners on the negative battery cable, and use them to secure the negative battery cable to the negative battery post (Figure 2). 2 1. Hex bolt 4. Negative battery post cap 2. Washer 3. Negative battery cable 5. Nut 6.
PAGE 3
2 3 Installing the Rear Hitch Setting Up the Motion-Control Levers Parts needed for this procedure: CE Machines Only 1 Rear hitch 2 Bolt (5/16 x 1 inch) 2 Locknut (5/16 inch) No Parts Required Procedure Procedure Install the bracket to the frame as shown in Figure 3 and Figure 4. 1. Locate the motion-control levers attached, but folded down on the machine. 2. Remove the upper bolt (3/8 x 1 inch) and washer; loosen the lower bolt (3/8 x 1 inch). 3.
PAGE 4
5 Completing the Setup Parts needed for this procedure: 1 Ignition key 1 Hose coupling (non-CE machines only) 1 Operator's Manual 1 Engine owner’s manual (non-Toro engines only) 1 Operator training material Checking the Tire Pressure Check the front and rear tires for proper inflation; refer to Checking the Tire Pressure in the Operator’s Manual for the recommended inflation pressure.