FORM NO. 3316-432 MODEL NO.
CONTENTS Page MODEL AND SERIAL NUMBER INSTALLATION v ATTACH HEIGHT CONTROL LEVER.. POSITION MOWER UNDER TRACTOR .. ATTACH MOWER TO TRACTOR .conventioneer INSTALL FRONT PULLEY SUPPORT INSTALL DRIVE BELT AND COVER... CHECKING MOWER LEVEL MOWER LEVEL TRACTOR LIFT BAR LIFT ROD ADJUSTMENT Page TRANSPORT LEVEL STOP ADJUSTMENT ..3 REMOVAL . OPERATION .. MAINTENANCE AND STORAGE BLADE MAINTENANCE UNDERSIDE CLEANING REPLACEMENT MOWER DRIVE BELT REPLACEMENT.. SPINDLE BELT REPLACEMENT GENERAL CARE AND STORAGE ..
MODEL AND SERIAL NUMBER A Model and Serial Number identifies your Toto Wheel Horse attachment. These numbers should always be referred to when consulting with your dealer or factory concerning service, replacement parts, or questions you may nave. For your reference, record numbers from Mendel and Serial Number plate on your attachment. MODEL SERIAL NO. INSTALLATION ATTACH HEIGHT CONTROL LEVER Height control lever must be attached to Rear Discharge 42 in, {107 cm) Mower, as described below.
I SUPPORT Will NOT LOCK INTO HITCH, TURN NOS CLOCKWISE FIG. 7. Install Pulley Support INSTALL DRIVE BELT AND COVER Tum belt tension adjustment knob all the way clockwise (Fig. 7). Install drive belt in groove of mower pulley and position belt strands around idler pulleys, with inside strand in āVā pulley and outside strand making a back bend around Hat idler (Fig. 8). Place drive belt on inside ft groove of PTO pulley (Fig. 9). % \emcee " FIG. 5. Align Fork with Sha Lift mower with tractor attachment lift.
s FIG. 10. Install Pulley Support Cover checked attire of initial installation and periodically as a check to see if alignment is maintained. MOWER LEVEL Position tractor on a level surface. Adjust all four tires o 12 Ibs. pressure. Place mower height control lever in middle cutting position. Tum mower blades front-to-back. Adjust distance from surface to blade tips equal to 1/8 inch front low (Figs. 11, 12, 13 and 15).
TRACTOR LIFT BAR-TRUNCATION AND LIFT ROD ADJUSTMENT This adjustment involves parts located contractor (Fig. 14}. Truncation on lift chain should be adjusted so that bumpers on draft bars of mower suspension come in contact with tractor footrests when mower is fully raised, with truncation stud in rear hole of tractor lift lever. TRANSPORT LEVEL STOP ADJUSTMENT For normal operation mower level stops should be adjusted so that carriage bolt heads are set at bottom of bracket slots.
grease gun will usually fill each spindle tater 50 hours use. Grease zeros are conveniently located at top of spindle shafts on three-blade mowers. Lubricate mower Gage wheels every 25 hours. Lubricate pirating arms and levers at 25 hour intervals with light machine oil applied directly to wear surfaces. Anti-scalp rollers should NOT be lubricated. LUBRICATE GAGE WHEELS 25 HRS, LUBRICATE MOWER SPINDLES 50 HRS, / ONCE A YEAR 591 FIG. 16.
Consumer Products THE TOR TOTAL COVERAGE GUARANTEE A Full Two~Year Warranty (Limited Warranty for Commercial Use) What is Covered By This Express Warranty? The Tore Company promises fo repair any TOR Product used for residential purposes if defective in materials or workmanship for a period of two years from the date of purchase. The cost of parts and labor are included, but the customer pays the transportation costs.