FORM NO. 3315-936 MODEL NO.
CONTENTS MODEL AND SERIAL NUMBER INSTALLATION .. ATTACH HEIGHT CONTROL LEVER .. POSITION MOWER UNDER TRACTOR ATTACH MOWER TO TRACTOR INSTALL FRONT PULLEY INSTALL DRIVE BELT AND COVER CHECKING MOWER LEVEL MOWER LEVEL TRACTOR LIFT BAR-TRUNCATION AND LIFT ROD ADJUSTMENT Page TRANSPORT LEVEL STOP ADJUSTMENT 3 REMOVAL .. . 4 OPERATION MAINTENANCE AND STORAGE LUBRICATION. BLADE MAINTENANCE UNDERSIDE CLEANING REPLACEMENT BELTS MOWER DRIVE BELT REPLACEMENT SPINDLE BELT REPLACEMENT GENERAL CARE AND STORAGE ..
MODEL AND SERIAL NUMBER A Model and Serial Number identifies your Toto Wheel Horse attachment. These numbers should always be referred to when consulting with your dealer or factory concerning service, replacement parts, or questions you may have. For your reference, record numbers from Model and Serial Number plate on your attachment. INSTALLATION ATTACH HEIGHT CONTROL LEVER Height control lever must be attached to Rear Discharge 42 in. (107 cm) Mower, as described below.
Vi FIG. 4. Open the Mid-Attach-A-Masc Hitch FiG. 7. install Purifier Support INSTALL DRIVE BELT AND COVER Tum bet tension adjustment knob all the way clockwise (Fig. 7}. Install drive belt in groove of mower pulley and position belt strands around idler pulleys, with inside strand in “v” pulley and outside strand making a back bend around flat idler (Fig. 8). Place drive belt on inside groove of PTO pulley {Fig. Digraphs Fork with Shaft Lift mower with tractor attachment lift.
Mow Er be Ck 4k oo taupe [ — T MEASURE HERE LEVEL SURFACE FIG. 11. Mower Level Measurement 5. blades have been sharpened a number of times, they may be too short to “overlap” each other, and must be replaced. if streaking persists after above possibilities have been eliminated as cause, adjust mower until deck is level, then turn adjustment nut “in” one complete turn, 10 shorten level adjustment rod and slightly raise front of mower.
TRACTOR LIFT BAR-TRUNCATION AND LIFT ROD ADJUSTMENT This adjustment involves parts located on tractor (Fig. 14). Truncation on fight chain should be adjusted so that bumpers on draft bars of mower suspension come in contact with tractor footrests when mower is fully raised, with truncation stud in rear hole of tractor fight lever. TRANSPORT LEVEL STOP ADJUSTMENT For normal operation mower level stops should be adjusted so that carriage bolt heads are set at bottom of bracket sits.
grease gun will usually fill each spindle after 50 hours use. Grease zeros are conveniently located at top of spindle shafts on three-blade mowers. Lubricate mower Gage wheels every 25 hours. Lubricate pivoting arms and Severs at hour intervals with light machine oil applied directly to wear surfaces, Anti-peals rollers should NOT by lubricated, FiG. 16. Three Blade Mower Lubrication Fittings BLADE MAINTENANCE A\ caution A Sharp edges of mower blades can cut you during blade maintenance or adjustment.
< mer THE TOR TOTAL COVERAGE GUARANTEE A Full Two Year Warranty {Limited Warranty for Commercial Use) What Is Covered By This Express Warranty? The Toto Company promises 1o repair any TOR Product used for residential purposes if defective in materials or workmanship for a period of two years from the date of purchase.