MODEL NOS. FORM NO.
CONTENTS Page MODEL AND SERIAL NUMBER ASSEMBLY 1 TRANSPORT LEVEL STOP ADJUSTMENT 5 ATTACH HEIGHT CONT REMOVAL .. "5 REAR DISCHARGE MOWER 1 OPERATION 5 ATTACH DISCHARGE CHUTE SIDE MAINTENANCE 5 DISCHARGE MOWER . 1 LUBRICATION 5 INSTALLATION Luuusussronen 1 BLADE MAINTENANCE 5 ATTACH MOWER TO TRACTOR 2 UNDERSIDE CLEANING 6 INSTALL FRONT PULLEY 2 REPLACEMENT BELTS & INSTALL DRIVE BELT AND 3 MOWER DRIVE BEL REPLACEMENT .. & CHECKING MOWER LEVEL ..
MODEL AND SERIAL NUMBER A Model and Serial Number identifies your Toto Wheel Horse attachment. These numbers should always be referred to when consulting with your dealer or factory concerning service, replacement pairs, or questions you may have. For your reference, record numbers from Mode! and Serial Number plate on your attachment. ASSEMBLY ATTACH HEIGHT CONTROL LEVER-REAR DISCHARGE MOWER Height control lever must be attached to Mower, as described below.
Turn front wheels of tractor fully left. Raise tractor at manual attachment lift, be sure lift handle “locks™ in attachment lit. raised position. T Slide mower under tractor until mower center leveler bar is directly under right side of tractor frame. ATTACH MOWER TO TRACTOR Lower tractor attachment lift, Remove washer and hairpin cotter installed on tractor lift bar pin (Fig. 7). Align §ift bar and pin {attached to tractor) with slot in mower leveler bar (Figs. 3 & 4), FIG.
IF SUPPORT WILL NOT LOCK INT. HITCH, TURN KNOB CLOCKWISE FIG. 9 Install Pulley Support INSTALL DRIVE BELT AND COVER Tum belt tension adjustment knob all the way clockwise (Fig. 9). Install drive belt in groove of mower drive pulley and position belt strands around idler pulleys, with inside strand in “V” pulley and outside strand making a back bend around flat idler (Fig. 10). Placedrivebeltoninside groove of PTO pulley as described in tractor Operator's Manual (Fig. 11}. FIG. 10.
FIG. 14 Level Adjustment Nut Under some unusual mowing conditions, mower may leave a “streak” of uncut grass, which can be caused by any of the following conditions: 1. Engine being operated at less than full throttle. 2. Dull blades or underside of mower deck clogged with matted grass. 3. Ground speed too high for conditions-adjust to 2 mph (3.2 kph), or less if necessary. 4. Streaking on turns indicates turns are being made 100 sharply. 5.
TRANSPORT LEVEL STOP ADJUSTMENT For normal operation mower level stops should be adjusted so that cartage bolt heads are set at bottom of bracket slots. If mower is not level, in fully raised position, level stops may be adjusted by moving them in bracket slots as required (Fig. 15, 16 0r 17). REMOVAL Set mower Gage wheels in lowest cutting position and lower mower with tractor lift. Turn front wheels all the way left. Turn drive bet tension adjustment knob clockwise all the way and remove belt from mower.
Teo obtain optimum mowing results, mower blades should be kept sharp and well balanced. To sharpen blades, remove mower from tractor and invert mower. Remove blades using optional Toto Wheel Horse spindle blade wrench. Refer to Pans Manual for part Number, Hold spindle hex with wrench while removing blade attaching nuts and washers from end of spindles.
Consume THE TOR TOTAL COVERAGE GUARANTEE A Full Two-Year Warranty {Limited Warranty for Commercial Use} What is Covered By This Express Warranty? The Toto Company promises to repair any TOR Product used for residential purposes if defective in materials or workmanship for & period of two years from the date of purchase. The cost of parts and labor are included, but the cornerstone pays the transportation costs.